Please excuse the fuzzy cell phone picture and messy carpet.

This is the result of Tail Blank Mold: Take 1. I learned a whole lot about casting expanding foam from making it, but unfortunately I'm going to have to start over. I cast the foam like an ice cream cone with the wide end being the opening, which resulted in foam collapsing and foam not filling the entire mold properly. Next time, I will have the opening be much smaller at the tip of the tail. When that mold is done, I'll do a more complete write-up on what I've learned.

I still managed to get one decent pull before I ran out of expanding foam. It didn't fill the entire mold cavity so it's a little short, but still pretty OK. I am using it to test out new techniques, including adding a furry mohawk. (Who likes SPARKLE FUR??? :D!!)

--Materials used--
Flex Foam-It! III from Smooth-On
Polar Fleece (to smooth it all out; this was not a pretty cast :/)
Lycra Spandex in... teal? I think it's teal. I got it during their moving sale.
2" nylon webbing. Next tail I make I want to try putting the loops in the base of the tail so it sits higher.