I'm posting this so people can see examples of my magnets and coasters-- I want potential customers to be fully aware of what you're getting when you commission from me.

The middle is a SIX INCH ruler for size comparison. The upper right is the back of a coaster. I use superglue and attach 1 mil foam, I believe. It might be a little thinner..but it holds up well, and won't come off the beads. Bottom right is the other side of a coaster- this is to show the relative size.

Upper left is a small sprite magnet. I usually cut and superglue strips of magnet to fit each individual sprite, and to make sure no pieces of the sprite don't stick to stuff. In this case, it's the Black Mage with stuff all over him. I haven't had a case of any magnetic strips falling off sprites yet. They're really on there.

The lower left is my flat iron stuff. I'm considering going into keychains, and this is the size of sprite that I would use for it. It's also what sprites look like when they are flat ironed..basically, ironed until the holes close up. I will probably use this style in making keychains, because they are flatter and more durable this way.

Hope this clears up any potential questions people might have.