FA+
Shop
267
Views
Views
6
Favorites
Favorites
Category
All / All
Species Unspecified / Any
Size 2576 x 1932
File Size 1001 kB
Report this content
More from jangofett777
Dan Wesson 4 inch airsoft revolver now with 2X the rails
the top rail was easy enough to get on, just remove the rear sights and slide the rail on then tighten it up then reattach the rear sights and done.
the lower rail was a bitch. for some unknown reason it wont just slide on like the top one so I had to take and old rubber mallet that I have laying around and hammer it as far as it would go and then tighten it up.
the lower rail was a bitch. for some unknown reason it wont just slide on like the top one so I had to take and old rubber mallet that I have laying around and hammer it as far as it would go and then tighten it up.
Category All / All
Species Unspecified / Any
Size 2576 x 1932px
File Size 1001 kB
from the videos I've seen on YouTube of people installing the lower rail it should have just slid onto the mounting point.
https://www.youtube.com/watch?v=2SAMTAE-MzM
https://www.youtube.com/watch?v=2SAMTAE-MzM
Comments