FA+
Shop
404
Views
Views
3
Favorites
Favorites
Category
All / All
Species Unspecified / Any
Size 1280 x 462
File Size 133 kB
Report this content
More from LogarthSheppy
I got a 3D Printer after putting it off for like a year and a half. Behold the crappy stuff I've made. Most of these prints are off of Thingiverse, but I did make the collets (bottom left) and modified the ANE icon to be printable (bottom middle). Yay!
Category All / All
Species Unspecified / Any
Size 1280 x 462px
File Size 133 kB
It is a direct copy. The only MINOR difference is, since it had to print flat on one side, the outer diameter is slightly wider on one side, but it is still the same width at the holes in the middle that stick out further. I've since put it into a LEGO gearset and it works flawlessly. PS: They grey gear is an actual LEGO gear put there for comparison.
Comments