O.o Sharp-pointed overhangs... The bane of FDM. I'm impressed those parts were able to be printed at all, in honesty. I do see a few printer issue errors though.

it's in several parts (legs, torso, head, tail, each wing, base) and I tried to rotate them as good as possible, like the head upside down. legs, too, because skirt, so the knee/feet spikes are kind of fucked XD
The tail I printed lying flat and it really doesn't look good because.. printing round things not perpendicular to the bed doesn't work too well

If the right arm was printed elbow-up, then you need to adjust speed on short layers and might need to upgrade your cooling fan or check on other related properties of the cooling fan. Unless it's ABS, in which case speed is the only solution.

But yeah, sharp bits pointing down are the bane. Like you said, that's why the spikes are unhappy. :) The slicer can do its thing, but trying to make that small a bit for the point with a separation between the support structure and the point is just not gonna happen.

it was indeed :) anbd frankly, I am such a beginner with printing that I rather not try adjusting speeds , I know I'll screw it up :)

Basic rule: Going slower is fine 98% of the time. The only thing it can do it make the print take longer. Most slicers have an option to slow down for layers that take under a certain amount of time too.

Some things just can't print well ever though. :(

it already took like 18 hours, I'm no patient man :)
but maybe I try that next time. and also just printing it larger which could fix some issues as well

18 hours? That's pretty fast. Anyway, the slowdown only needs to happen on "small layers".

Sadly, making it bigger won't help hanging tips. They always come to a point. Only chopping off the tip can help so it creates a larger area.

yes, but with larger sizes, the tips being blunt won't be so obvious as it's just the tip and not half the spike :)

oh neat :o

Also ich finde es für einen "ersten" Versuch eigentlich doch ziemlich gelungen, sieht jedenfalls nicht schlecht aus. :)
Wie gut ist das Material danach zum weiterarbeiten? Also tust du ggf. dann so nach ein paar Fehler ausbügeln der versuchst du den Druckvorgang so gut wie möglich zu perfektionieren?

naja, kanten feilen könnte man wohl, aber sonst.. ich versuch besser gleich richtig zu drucken ;)
und war der zweite versuch.. erster versuch war weit kleiner und da ging gar nix XD

Wie gross ist die Figur denn?

Wenn es besser wird, je grösser gedruckt wird muss man es wohl oder übel halt in Originalgrösse drucken :P

Ich glaub das kriegt mein drucker nicht hin :)
und is so 17 CM, basis zu horn

Now paint her! .o.

maybe if I make a better print ;)

Make a better print, then paint her xD

It will "only" take a good couple of hours xD

I don't even have colors to paint :) but I have purple filament XD