FA+
Shop
176
Views
Views
1
Favorites
Favorites
Category
Photography / All
Species Unspecified / Any
Size 600 x 1011
File Size 125 kB
Report this content
More from prplhaze
A rosary I created for a store here in town. It is based off a St. Michael's one that I found on the internet.
It is stainless steel, and is the first piece of chainmail I have created in about 3 years. The mobius balls were created during my lunch at work, and the diamond shaped sections are a pattern that I invented a while ago, and came from an existing piece.
It is stainless steel, and is the first piece of chainmail I have created in about 3 years. The mobius balls were created during my lunch at work, and the diamond shaped sections are a pattern that I invented a while ago, and came from an existing piece.
Category Photography / All
Species Unspecified / Any
Size 600 x 1011px
File Size 125 kB
Thanks for the reply! The rings started out as a coil of wire that was cut into the rings. Then it was just time and 2 pairs of pliers to create each section. There are sites that provide pre-cut rings (the stainless steel that I used here was pre-cut) such as The Ring Lord (http://theringlord.com/) and they also have a forum where you can get tips and such if you wanted to create your own stuff.
Hope you have a good day.
prplhaze
Hope you have a good day.
prplhaze
Comments