(keep watching this submission. It will be updated over time until completed.)

!!!you may need to delete cached images for this page to view the update!!!

Third update: got the last bit of detail added. This truck is ready to be rusted!

Second update: worms eye view again. Of course the parallax is not correct. No matter how far away the truck is you still wouldn't see the headlights if your eyes were 1 inch off the floor at max. But... I got something I think for everyone!

Tire treads, drive shaft, undercarriage, exhausting, wheelie, massive truck.

First update: got it traced and shaped it down. Apparently I was following the king ranch layout too closely and forgot this little dually doesn't have a king crew cab. Just enough room for like... Spare shovels ..

Finally finished the chassis. My goodness this was faster than drawing up the front.

So. The front end is made up. The back end is as much as I could take in looking at chassis setups from the top down. Since I do not really have any good pictures of a truck turned on its side minus wrecks? This is as close as I can get to the real thing. That crank case though. I had no idea how massive those things are. They almost look like an inverted cone going the wrong direction.

Anyway I covered it in plastic and I know I am missing the front turning rods. They are visible on the titan warrior but here they are missing. I'm about to add them in before starting the real tracing.