Colab skunk head project with Pulsifer is complete.
Category All / All
Species Unspecified / Any
Size 1280 x 855px
File Size 140.2 kB
We did not make the tounge partially due to the call from my dad about my stepmom in the middle I think. We did the mouth with fleese I laid a small square on the bottom and cut along the edge to match the jaw. Then I hand sewed the fleese to the fur and did the same with the top. The we glued in the teeth... unfortunatly the teeth were a little heavy and it had a weird slack jawed look. tightning the rubber bands made it a bit better but the jaw looks off now a little...... And yes I do think that is your kigu design. I saw it on her design board and it looked hecka cute!
FA+

Comments