Someone on discord suggested I post this mid make photo to show off the mouth detail and talk about some of the process so here you go: the Teeth are made from Thermo plastic, I boiled them in water and pushed them by hand into silicone moulds. The gums took the most amount of energy they’re made from fibre glass, I started with a clay sculpt version made in the actual head then covered them in four layers each of pour on silicone which in turn was covered in fibre glass to make the mould then they were flipped the clay taken out and fibre glass added to make the final gums then using a soldering iron I melted the thermoplastic teeth in after both were painted and given a coat of clear lacquer to make them look wet.