I'm way jealous. v.v

:D that looks awesome

Glad you like it. It looks much better in person. I did not like how they look in the photos. Also the coloring from the LED when it is on is more of an amber color then a true yellow. I hope this is okay. It is hard to tell from the photo.

thats fine. it will match my retarded yellow fur better then lol

That's awesome! How much would you sell something like this for?

Thanks. ^.^
As for how much I would charge depends on exactly what someone was looking for. Just the claws with out a light would run about $1.50 each. then add a standard LED( Red, Green or Amber/Yellow) to each claw would cost and additional $1.50 or so. Then $7 for the wiring for each Paw. So a Five clawed paw with LED's would cost about $22 each. But then you would need to get a power wiring harness to power all the claws in the suit and it has an on/off switch. That cost varies based on how many paws it has to power, or if it needs to power the head and or tail.

Do you make resin eyes too? & can you get white LEDs?

Yup, I can. I can do Resin Follow-me eyes too. White/Clear LED's should be added to the list of Standard LEDs for the same price. I can do other colors too, but those LED's are more expensive and would cost a little more depending on the color or any special effects (like flashing).

Okay. Thanks again

Okay. Thanks for answering. I'll keep this in mind for future fursuits.

No problem =3

How do you set the light into the claw? Do you just stick it in there while the resin is still liquid?

You can, but it is harder that way. You need to have something to hold the LED in place while the resin cures. Instead I just drilled a hole in the bottom that the LED fits tightly into.

Ooh thanks for responding so fast!! I recently got some resin claws and wasnt sure how to put my LED in em. What type of adhesive do you use?

The LEDs fit pretty snug into the claw, so I use just a little hot glue to secure them

Awesome, Thanks again!