FA+
Shop
313
Views
Views
7
Favorites
Favorites
Category
Crafting / All
Species Unspecified / Any
Size 1280 x 994
File Size 315.7 kB
Report this content
More from AtypicalDem
Here is a neat little tool I made for the angle grinder. It's meant to be able to take off the flange nut when changing a disk. This tool was made to be adjustable.
The tool was forged from a small length of coil spring. The two ends of the hinge area were forged at opposite ends of the section of spring and was cut in half at the middle portion.
Legs were drawn out to take length and remain flat for strength when twisting the nut.
The tool was forged from a small length of coil spring. The two ends of the hinge area were forged at opposite ends of the section of spring and was cut in half at the middle portion.
Legs were drawn out to take length and remain flat for strength when twisting the nut.
Category Crafting / All
Species Unspecified / Any
Size 1280 x 994px
File Size 315.7 kB
There is one specifically for bikes. There are "general purpose" threaded caps and nuts that have two divots in the top flat surface for a wrench like this, something like https://www.mcmaster.com/browse-fas.....panner-nuts-6/ .
Comments