Have you ever wanted to 3D Print your own fursuit head base but didnt know where to start?
Now you can! :D

Etsy: https://www.etsy.com/listing/1731832952/
Cults3D: https://cults3d.com/en/3d-model/fas.....15mm-fan-mount

Edit this bad boy in any 3D modeling software and call it done!
Sell your remix, sell 3D prints, make customs and take commissions!
I've done all the hard work for you!
It is pre-sized to fit a BambuLab P1P 3D Printer and fits a 22" head with wiggle room for foam padding! So it should fit most noggins.
You can split it to print on smaller print beds if needed.
It also has built in fan mounts for easy install and keeping you cool!
The wall are thin enough to be light but sturdy to handle most shoulder to floor drops!