FA+
Shop
982
Views
Views
6
Favorites
Favorites
Category
Photography / Miscellaneous
Species Unspecified / Any
Size 600 x 803
File Size 119.2 kB
Report this content
More from frazzles626
Built this machine using scrap steel and parts off ebay. Very cheaply made but will do the job. consist of a Gear Reduction AC motor. Brass bushings, 1/2" Hardened steel shafts locking collars and I used a Marine grade Pinion Gear in which was the most expensive part at 12 bucks. .. Overall I built a Machine that can handle Rotomolding 26" parts :) Not a bad deal for when these machines go for hundreds of dollars. Its all welded. Gotta love welding. its cheap and very strong. All I have left is to wait for the Chain to arrive in the mail.
Category Photography / Miscellaneous
Species Unspecified / Any
Size 600 x 803px
File Size 119.2 kB
Actually it will sit in my Casting and molding room in the basement as all the materials get too cold up here in my garage during the winter :) Its a small little room but it does the job.
As for the welder, You don't need some crazy expensive Welder, Somewhere between 200-300 Dollars, Wire feed welder will do just fine. I have been using mine for years
As for the welder, You don't need some crazy expensive Welder, Somewhere between 200-300 Dollars, Wire feed welder will do just fine. I have been using mine for years
Hey You!
Haha It more the other way around! Anyone could really weld something together its not that hard. But doing what you do is something I can only dream of doing! Your artwork and the personality and love you put into your Art is just jaw dropping amazing and is something I don't think I will ever be able to master :(
But thank you for the support Hopefully I will use the machine for a few projects I would love to start to make negative molds of. But I still have a lot of finishing work to do on them.
Haha It more the other way around! Anyone could really weld something together its not that hard. But doing what you do is something I can only dream of doing! Your artwork and the personality and love you put into your Art is just jaw dropping amazing and is something I don't think I will ever be able to master :(
But thank you for the support Hopefully I will use the machine for a few projects I would love to start to make negative molds of. But I still have a lot of finishing work to do on them.
I am probably going to try and do the Rocket portion of the Podgy Panda Rocket figure first. Its small simple and should not be a problem..
http://www.furaffinity.net/view/4199360/
http://www.furaffinity.net/view/4199360/
Comments